With the improvement of economic development,
solar street lighting has become an integral part of beautifying the urban landscape. Therefore, in order to ensure the
Solar Street Light project, street light appliance suppliers and installers should actively intervene in the solar road lighting project in advance. The following points should be paid attention to in the street light installation:
1. In rock formations and weathered stone areas, scattered grounding and segmented grounding are difficult to meet the requirements. You can consider the galvanized flat steel and other conductors to be connected according to the design requirements. The connection should be reliable. At the same time, appropriate protective treatment and pre-embedded The foundation is reliably connected to ensure that each light pole is reliably connected to the ground. The high pole lights in solar street lights are scattered, and they mainly rely on basic grounding. If necessary, use resistance reducing agents to reduce grounding resistance. Linyi lamps wholesale
2. Hoisting operations must strictly follow the operating procedures. Pay special attention to the power grid lines and other lines around the hoisting equipment, as well as the surrounding structures. The hoisting points should be reasonable during hoisting and should be adjusted in time after positioning.
3. Pay attention to the beauty of the
solar Street light pole after installation. Starting from the foundation construction, the straightness of the lamp position should be controlled based on the main line, and the line shape of the road design should be changed reasonably. The lamp pole should be straight, and the welding seam and access opening should be avoided in the main line direction, and the whole line should be consistent. The inclination of the cantilever of the light pole should maintain the coordination of direction and angle.
4. The internal fittings of the solar street lamp should be inserted tightly and firmly to avoid failure caused by loose wind pendulum and poor contact. Solar street light fixtures and lamp poles, lamp poles and cantilevers are reliably fixed. The middle and high pole lights of solar street lights must be fitted with each pole in place, the lifting frame and lamps must be reliably fixed, the lifting system must be safe and reliable, and the functions of lifting, limiting, and positioning must be complete.
5. A comprehensive understanding of the characteristics of solar street lamps, light sources, and poles. According to the actual and reference lighting standards on the road, combined with the investment budget, the solar lamps, light sources, and poles should be selected reasonably to give full play to the high efficiency and energy saving of the light sources. The advantages of light distribution and accessory combination.
6. Under the conditions of guaranteed lighting performance, appropriately increase the distance between solar street light lamps to save the number of lamps; appropriately increase the height of
Solar Street Light Poles to improve the lighting effect; as far as possible, place poles in the middle of the road to save engineering cost.
7. According to the actual and geological conditions of the
solar street light engineering site, design and manufacture the base of the solar street light pole and the base of the high pole lamp to ensure that the foundation is firm and reliable. Special attention should be paid to the adaptation of the embedded bolts to the reserved holes of the rod seat, accurate positioning, reasonable embedded length and outer length, and the threaded part should be properly protected to facilitate lifting and positioning.
8. In combination with road engineering, intervene in pole position selection, foundation construction and pre-embedding in advance in time to discover problems in time, make reasonable changes, ensure quality, and save investment
